ATEN CS-62A User Manual download pdf (Page 3)

Installation

Important

1. Before you begin, make sure that the power to all the devices you will be connecting has

been turned off. You must unplug the power cords of any computers that have the

Keyboard Power On function. Otherwise, the switch will receive power from the computer.

2. To prevent damage to your equipment, make sure that all the devices you will be

connecting are properly grounded.

Installing your new KVM-0213 involves the following steps:

1. Plug your keyboard, monitor, and mouse into the Console ports on the KVM-0213. Each

port is labeled with an appropriate icon.

2. Plug your speakers into the KVM-0213’s speaker jack. *This step is optional

3. Plug the attached KVM cables’ keyboard, monitor, mouse, and speaker connectors into

their respective ports on the computers you are installing.

After you have finished attaching the cables, turn on the power to the computers.

Note: The KVM-0213’s Power On default is to link to the first computer you turn on.

Operation

Hotkey Port Selection

All hotkey port switches begin with tapping the Scroll Lock key twice.

[Scroll Lock] [Scroll Lock]

Invokes Auto Scan Mode

Starts Auto Scan. Press and release the [Left Shift] key, and then press the [Right Shift] key.

[Left Shift] [Right Shift]

Scan Interval

Sets the Auto Scan interval to n second intervals - where n is a number from 1 – 4.

[Left shift] [Right shift] [S] [n]

The n stands for the number of seconds that the focus dwells on a port

before switching to the other one. Replace the n with a number

between 1 and 4 when entering this hotkey combination. (See the

table, below.)

1 2 3 4 5

No comments

ATEN CS-62A User Manual Page 3