ATEN Interface Converter IC-485SI User Manual download pdf (Page 4)

IC-485S/IC-485SI

FUNCTION OVERVIEW

1-2 SPECIFICATIONS

Connector

RS-485/422:

A 4 terminal block

and RJ-1

GND

TAB**

SWl:DCE,DTE,

MONITOR*

selection

Function Switch

SW2:TxON.

RxON

SW2:TxRTS,

RXXrt

SW2:TxRTS.

RxON

Enclosure

Plastic

Weight

60 gm

Dimensions

54x74.5x18.5mm

Figure l-2 IC-485 Specifications Table

* RJ-11 Connector

Monitor mode for

IC-485S only.

* * Grounding TAB for IC-485SI only.

User’s Manual

INSTALLATION

IC-485S/IC-485SI

2 INSTALLATION

2-1 INSTALLATION PROCEDURE

Before installing the IC-485 you will need a

wire cable. This cable must go from your location to

the place you want to connect to.

Installation Procedure:

Before installing the IC-485 to the PC, decide

one of the 6 possible configurations suitable

for your application. Please check Chapter 3

OPERATION for correct slide switch settings

and phone wires connection, then connect

IC-

485 to the PC.

For IC-485SI: Connect a wire from the

Grounding Tab to the earth

ground.

Turn on PCs.

Insert the adapter’s plug into the POWER

JACK in the right side.

Plug the power adapter into an AC outlet. The

unit is now ready for operation.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

ATEN Interface Converter IC-485SI User Manual Page 4

Comments to this Manuals

Related products and manuals for Serial converters/repeaters/isolators ATEN Interface Converter IC-485SI