ATEN CM1164 User Manual download pdf (Page 55)

Chapter 6. OSD Operation

OSD Operation and Menu

There are three ways to cycle through the OSD menu, go to submenus, change/

adjust the options and make a selection, as follows:

 Front panel pushbuttons – Use the Fn1~Fn4, Select and OSD

pushbuttons located on the front panel. The Fn1~Fn4 buttons correspond

to up / down / left / right directions. Use Select to enter an option and OSD

to exit a menu. See Front View, page 6.

 IR remote control – See IR Remote Control, page 8.

 Keyboard – Use the Arrow keys to move through the menus, the Enter

key to select and save options, and the Esc key to exit.

 Mouse – Point and click Once to enter menu pages and click Twice to

select, change and save options, or enter sub-menu pages.

The OSD menu options are shown in the table below. The highlighted texts

indicate the CM1164’s default setting.

Menu Page Sub-Menu Page(s)

Port

Selection

Sets a Function Mode, Display Mode,

or switches with Port Selection and

Station Selection.

See Port Selection, page 45.

Mode Quadview See Quadview, page 46.

PiP Dual

See Picture in Picture (Dual / Triple /

Quad), page 47.

PiP Triple

PiP Quad

Disable Channel See Disable Channel, page 48

Quadview Resolution See Quadview Resolution, page 49.

Startup Display Mode See Startup Display Mode, page 50

DCC Select the Station and Port to switch

keyboard and mouse control to in a

DCC installation.

See DCC, page 51

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 99 100

No comments

ATEN CM1164 User Manual Page 55