ATEN PE6208 User Manual download pdf (Page 17)

Chapter 1. Introduction

Optional Accessories

Sensors

Sensors are optional accessories. You can use the eco PDU unit without

sensors. However, if you want to have complete energy management of an

instrumented data center with the use of the eco PDU, you would need to use

eco Sensors software and install 4 sensors for each of the racks to generate a

complete energy-efficient data and chart. Higher sensor installation density is

helpful to generate more accurate data. 8-port models have 2 sensor ports. In

this case, Sensor 1 needs to be installed at the intake of the rack and sensor 2

needs to be placed at the exhaust of IT equipment of the rack. A sensor-enabled

installation is required to generate a more complete energy-efficient data and

chart. Higher sensor installation density is helpful to generate more accurate

data. Available sensors are show in the table, below:

Sensor Management

Sensors can be managed via the eco PDU’s built-in graphical user interface

(GUI) or with the ALTUSEN eco Sensors software that can be downloaded

from the ATEN website. The download link can be found on the software CD

provided with the eco PDU package.

Cable Holders

Cable holders are optional accessories. For added safety, use ATEN Lock-

Your-Plug cable holders to secure the cables from your attached devices in

place on the eco PDU unit. Use only the ATEN Lock-Your-Plug cable holders

that have been specifically designed to work with the eco PDU. Using any

other kind of cable securing device could be highly dangerous.

Sensor Part Number

Temperature EA1140

Temperature / Humidity EA1240

Differential Pressure / Temperature EA1340

Cable Holder Part Number

Lock-Your-Plug 0X12-0017-300G

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 81 82

No comments

ATEN PE6208 User Manual Page 17