Installation Guide GN0116 Guardian Over the NET™ www.aten.com
w w w . a t e n . c o mCorporate HeadquartersATEN International Co., Ltd. 3F, No.125, Sec. 2, Datung Rd. Sijhih City, Taipei 221, TaiwanPhone: +886-2-
01 Installation Process Product Front View (Front View) 1. Programmable AC Power Outlets Product Rear View 1. AC Power Source Inlet 2.
Hardware - Basic Installation 02 > Power Connection 1. Connect one end of the bundled Power Adapter to the AC power source and the other end t
IP Setting Once the basic hardware installation is complete, an IP address must be acquired/set for the GN0116 to allow access. Ì Insert the bundl
04 Guardian Monitor Center network diagram: After downloading and installing the Guardian Monitor Center on the computer*, use the IP address of t
>Temperature Sensors 05 The GN0116 includes two sets of temperature sensors. Each set contains two sensors. The included temperature sensors ar
06 > Voltage Detector / Current Detector / Humidity Sensor Apart from the bundled sensors and devices sold on the market, ATEN also offers three
07 Connect the other end of the cable to the Terminal Block slot on the EA2110. le to ecting to the GN0116. can not only measure the current
08 Humidity Sensor nd one outlet itor ble to connect the Inlet Port cted, t the RJ-45 port on the EA2310 to the GN0116. EA2310 – Voltage Detector
Comments to this Manuals