ATEN CM1164 User Manual download pdf (Page 42)

CM1164 User Manual

Hotkey Setting Mode

Hotkey Setting Mode is used to configure your CM1164 with hotkeys. All

hotkey operations begin with invoking Hotkey Setting Mode (HSM) – then

hotkeys can be used to make changes.

Invoking HSM

To invoke HSM do the following:

1. Press and hold down [Num Lock].

2. Press and release [-].

3. Release [Num Lock].

Note: The keys for invoking HSM can be change. See Hotkey Selection Mode,

page 54 for details.

When HSM is active, the Caps Lock, and Scroll Lock LEDs flash in succession

to indicate that HSM is in effect. They stop flashing when you exit HSM.

Ordinary keyboard and mouse functions are suspended – only Hotkey

keystrokes can be input.

At the conclusion of some hotkeys, you automatically exit HSM. With other

operations, you must manually exit HSM. To exit HSM manually, press [Esc]

or Spacebar.

The table below describes the actions of each hotkey. First invoke HSM then

enter the hotkey.

Hotkey Action

[A] Starts Auto Scan. See Auto Scanning, page 32

for more information.

[Enter] Switch to the next computer.

(1 to 2, 2 to 3, 3 to 4, and 4 to 1.)

[Port ID] [Enter] Switch to the computer device that corresponds

to the Port ID (1, 2, 3, or 4) entered.

[Port ID] [K] [Enter] Brings only the KVM focus from the port that

currently has it to the computer that corresponds

to the Port ID entered. The USB and audio focus

do not change.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 99 100

No comments

ATEN CM1164 User Manual Page 42