ATEN CS-1762 User Manual download pdf (Page 15)

Chapter 2

Hardware Setup

Cable Connections

To set up your CS1762 / CS1764 USB DVI KVMP Switch installation, refer

to the installation diagram on the following pages (the numbers in the diagrams

correspond to the steps, below), and do the following:

1. Plug your USB keyboard and USB mouse into the USB Console Ports

located on the unit’s front panel.

2. Plug your microphone, speakers, and monitor into the Console ports

located on the unit’s rear panel.

3. Using a KVM cable set (provided with this package), plug the DVI

connector into any available DVI socket in the CPU Port section of the

switch, then plug the accompanying USB, microphone and speaker

connectors into their corresponding USB, microphone, and speaker

sockets.

Note: Verify that all the plugs are in the same CPU Port sockets (all in Port

1, all in Port 2, etc.), and that each socket is marked with an

appropriate icon to indicate itself.

4. At the other end of the cable, plug the USB, video, microphone, and

speaker cables into their respective ports on the computer.

5. Plug your USB peripherals into the type A sockets in the USB hub section.

6. Plug the power adapter that came with your switch into an AC power

source, then plug power adapter cable into the switch’s Power Jack.

7. Turn on the power to the computers.

1. Important safety information regarding the placement of this

device is provided on page 29. Please review it before

proceeding.

2. Make sure that power to all the devices you will be installing has

been turned off. You must unplug the power cords of any

computers that have the Keyboard Power On function.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

No comments

ATEN CS-1762 User Manual Page 15