ATEN VS1601 User Manual download pdf (Page 16)

Chapter 2

Hardware Setup

Installation

Installation is quick and easy. See Installation Diagram, page 7 for reference.

Note: Before starting the installation, make sure that power to all the devices

to be connected to the VS1601 is turned off.

1. Plug the monitor or digital projector cable into the unit's Monitor port.

2. Connect speakers to the unit’s audio output port.

3. Plug one end of a video cable (refer to the System Requirements section on

p. 2), into any available video port on the unit; plug the other end into the

computer's video output port.

Note: One video cable is supplied with this unit. Additional cables require

an extra purchase.

4. Use a male/male audio cable to connect the computer’s speaker output

port with the audio input port of the video port selected in step 4.

5. Repeat steps 3 and 4 for each computer you wish to install.

6. Plug the power adapter (supplied with this package) into an AC source,

and then plug the power adapter cable into the unit's Power Jack.

7. Plug the IR Receiver cable into the IR Receiver port at the front of the

main unit (this step is optional).

8. Power On all equipment.

1. Important safety information regarding the placement of this

device is provided on page iv. Please review it before proceed-

ing.

2. Make sure that power to all the devices you will be connecting

up have been turned off. You must unplug the power cords of

any computers that have the Keyboard Power On function.

VS-1601.book Page 6 Tuesday, January 16, 2007 12:15 PM

1 2 ... 11 12 13 14 15 16 17 18 19 20

No comments

ATEN VS1601 User Manual Page 16