ATEN PN5212 User Manual download pdf (Page 95)

Chapter 7. Device Management

Customization

The Customization page is used to set Login Failure and Working Mode

parameters.

 Allowed sets the number of consecutive failed login attempts that are

permitted from a remote user.

 Timeout sets the amount of time a remote user must wait before

attempting to login again after exceeding the number of allowed failures.

Working Mode

 If ICMP is enabled, the Power Over the NET

device can be pinged. If it

is not enabled, the device cannot be pinged. The default is Enabled.

 To permit browser access to the Power Over the NET

device, click to put

a check mark in the Enable Browser checkbox. If browser access is not

enabled, users must use the Java Client AP program to access the switch.

The default is Enabled.

 Enabling Multiuser operation permits up to 32 users to log in at the same

time to share the remote bus. If not enabled, only one user can log in at a

time. The default is Enabled.

When you have finished making your settings on this page, click Save.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 152 153

No comments

ATEN PN5212 User Manual Page 95