ATEN KL1100 User Manual download pdf (Page 15)

Chapter 1. Introduction

LCD Module

No. Component Description

1 LCD Display To access the LCD monitor, slide the LCD module out and flip

up the cover. See Opening the Console, page 15, for details

on sliding the LCD module out.

2 LCD Controls These buttons control the position and picture settings of the

LCD display. See LCD OSD Configuration, page 22, for

details.

3 LCD On/Off

Button

Push this button to turn the LCD monitor on and off. The

button lights when the LCD monitor is off to indicate that only

the monitor is off – not the KVM switch itself.)

4 Firmware

Upgrade Port

The Firmware Upgrade Cable that transfers the firmware

upgrade data from the administrator's computer to the KL1100

plugs into this RJ-11 connector.

5 Firmware

Upgrade Switch

During normal operation and while performing a firmware

upgrade, this switch should be in the NORMAL position. If a

firmware upgrade operation does not complete successfully,

this switch is used to perform a firmware upgrade recovery.

See Firmware Upgrade Recovery, page 31, for details.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

No comments

ATEN KL1100 User Manual Page 15