ATEN VS0401 User Manual download pdf (Page 17)

Chapter 3

Operation

Overview

The VS0201 / VS0401 2/4-Port VGA Switch with Audio offers easy source

device selection with either the front panel pushbuttons, IR remote control, or

RS-232 serial interface. This chapter describes Source Selection, Power on

Detection mode, Pushbutton Lock, Powering Off/Restarting, and the RS-232

serial port configuration and commands.

Note: Whenever the VS0201 / VS0401 is powered on, it automatically

remembers the last connected port being used and connects to it.You

may choose one of the methods outlined below to select a different port.

Manual Source Selection

To select the source device to view on your VGA display, press the front panel

pushbutton that corresponds to the port it is connected to.

Note: The Port LED (green) light indicates which port is currently selected.

Remote Control Source Selection

First plug the External IR Receiver into the rear of the VS0201 / VS0401, place

the receiver where the IR signal can be reached, and aim the remote at the

External IR receiver.

To select a source device with the remote control, press the number button that

corresponds to the port it is connected to, or cycle through the source devices

by pushing the Port Up and Port Down buttons on the remote control unit, as

such:

 Use the Port Up button to select the next port in ascending order (from left

to right on the front view panel).

 Use the Port Down button to select the previous port in descending order

(from right to left on the front view panel).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 30 31

No comments

ATEN VS0401 User Manual Page 17