ATEN CS1762a User Manual download pdf (Page 21)

Chapter 2. Hardware Setup

CS1764A Cable Connections

To set up your CS1764A installation, refer to the installation diagram on the

following page (the numbers in the diagrams correspond to the steps, below),

and do the following:

1. Plug your USB keyboard and USB mouse into the USB console ports

located on the unit’s rear panel.

2. Plug your console monitor into the DVI console port located in the unit’s

rear panel and power on the monitor.

3. Plug your main microphone and speakers into the console microphone and

speaker jacks located on the unit’s front panel. The microphone and

speakers plugged into this panel have priority over those in the rear panel.

4. Plug your secondary microphone and speakers into the console audio ports

located on the unit’s rear panel.

5. Using a KVM cable set (provided with this package), plug the DVI

connector into any available DVI socket in the KVM port section of the

switch, then plug the accompanying USB, microphone and speaker

connectors into their corresponding USB, microphone, and speaker

sockets.

Note: Verify that all the plugs are in the same KVM Port sockets (all in

Port 1, all in Port 2, etc.), and that each socket is marked with an

appropriate icon to indicate itself.

6. At the other end of the cable, plug the USB, video, microphone, and

speaker cables into their respective ports on the computer.

7. Plug your USB peripherals into the type A sockets in the USB hub section.

8. Plug the power adapter that came with your switch into an AC power

source, then plug power adapter cable into the switch’s Power Jack.

9. Turn on the power to the computers.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 48 49

No comments

ATEN CS1762a User Manual Page 21