ATEN CS1762a User Manual download pdf (Page 24)

CS1762 / CS1764A User Manual

Powering Off and Restarting

If it becomes necessary to Power Off the CS1762 / CS1764A unit, before

starting it back up you must do the following:

1. Shut down all the computers that are attached to the switch.

2. Unplug the switch’s power adapter cable.

3. Wait 10 seconds, then plug the switch’s power adapter cable back in.

4. After the switch is up, Power On the computers.

Port ID Numbering

Each KVM port section on the CS1762 / CS1764A switch is assigned a port

number. ( 1 or 2 for the CS1762; 1 to 4 for the CS1764

A). The port numbers

are marked on the rear panel of the switch (see page 8 for details).

The Port ID of a computer is derived from the KVM port number it is

connected to. For example, a computer connected to KVM port 2 has a Port ID

of 2.

The Port ID is used to specify which computer gets the KVM, USB peripheral,

and audio focus with the Hotkey port selection method (see page 18 for

details).

Alternative Manual Port Selection Settings

When Hotkey Setting Mode has been activated, pressing [S] will invoke the

alternative front panel pushbutton manual port selection functions as follows

(see page 24, also):

 Press a port selection pushbutton once to bring the KVM, audio and USB

focus to the computer attached to its corresponding port.

 Press a port selection pushbutton twice to bring the audio focus to the

computer attached to its corresponding port.

 Press and hold a port selection pushbutton for more than 2 seconds to

bring only the KVM focus to the computer attached to its corresponding

port.

 Press and hold port selection pushbuttons 1 and 2 for more than 2 seconds

to start Auto Scan Mode, see page 19 for details.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 48 49

No comments

ATEN CS1762a User Manual Page 24