ATEN ALTUSEN PN9108 User Manual download pdf (Page 74)

PN9108 User Manual

Dial Out Connection

This configuration sets up a connection for the PN9108 to an ISP's site. You

can use the dynamic IP address that the ISP assigns to the PN9108 to access it

with a browser.

Connection Setup

1. Set up your hardware configuration to match the diagram, below:

Note: Use a standard 9 pin serial modem cable to connect the modem to

the PN9108's RS-232 port.

2. In the Out of Band Configuration dialog box (see page 47):

a) Make sure that the Enable dial-out function setting is enabled (there is a

check mark in the box).

b) Fill in the Com Port, ISP, and Modem settings with values appropriate

for connecting to your ISP.

Note: 1. If your modem isn't in the drop down list, select Generic

Modem as the modem type.

2. If you choose Generic Modem, you must specify any

necessary initialization commands in the Initialization String

textbox. The commands should be separated by a semicolon

( ; ). If you leave the initialization string blank, the PN9108

will only issue the atdt command.

Modem

Phone Line

PN9108

Serial Cable

ISP

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 103 104

No comments

ATEN ALTUSEN PN9108 User Manual Page 74