ATEN CS-1008 User Manual download pdf (Page 43)

4. OSD Operation

F7: SCAN

This function allows you to automatically switch among the available

computers at regular intervals so that you can monitor their activity without

having to take the trouble of switching yourself.

 The selection of computers to be included for auto scanning is made with

the Scan/Skip mode setting under the F3 SET function (see page 26).

 The amount of time that the focus stays on each port is set with the Scan

Duration setting under the F3 SET function (see page 26).

 As each computer is accessed, an ‘S’ appears in front of the port ID

display to indicate that it is being accessed under Auto Scan mode.

 While you are in Auto Scan mode, you can pause the scanning in order to

keep the focus on a particular computer either by pressing P, or with a left

click of the mouse. To resume scanning, press any key or left click, again.

See Invoking Auto Scan, p. 37, for further details.

 To exit Auto Scan mode and stay at a particular location, press

[Spacebar]. If the scanning stops on an empty port, or one where the

computer is attached but is powered off, the monitor screen will be blank

and the mouse and keyboard will have no effect. Simply wait – after the

Scan Duration time is up, the scan function will move on to the next port.

 While Auto Scan mode is in effect, the console will not function normally.

You must exit Auto Scan mode in order to regain control of the console.

 To exit Auto Scan mode, press [Spacebar] or [Esc].

cl1008-1016.book Page 33 Thursday, January 20, 2011 5:24 PM

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 72 73

No comments

ATEN CS-1008 User Manual Page 43