ATEN KN1108v User Manual download pdf (Page 227)

Chapter 12. Port Operation

211

Users and Buses

 The KN2132, KN2124v, and KN2140v only support two remote buses.

The first, third, fifth, etc., users to log in are all on one bus; the second,

fourth, sixth, etc., users to log in are all on the other bus.

 The KN4116, KN4132, KN4142v, and KN4140v support four remote

buses. The first, fifth, ninth, etc. users are all on the first bus; the second,

sixth, 10th, etc.; users are all on the second bus; the third, seventh, 11th,

etc.; users are all on the third bus; the fourth, eighth, 12th, etc.; users are

all on the fourth bus.

 All KVM Over the NET™ switches support independent bus switching.

With independent bus switching, if a user switches to a port that is being

utilized by someone on a different bus, only the user that switched ports

goes to the new port and the new bus – the other users on the original bus

remain on the original port and original bus.

Note: 1. Independent bus switching does not work when Auto Scan Mode

or Panel Array Mode is being used by one of the members of the

bus.

2. If Enable First Rider Transfer is enabled (see page 146), only the

first user on a bus can switch to an un-accessed port. Other users

on the bus cannot switch ports unless there is a bus that is already

connected to the port they would like to access, or there is a free

bus available.

 We recommend that the user who starts Panel Array Mode set it to display

at least four panels. Otherwise, it is possible that the other users may only

receive part of the picture.

1 2 ... 222 223 224 225 226 227 228 229 230 231 232 ... 283 284

No comments

ATEN KN1108v User Manual Page 227