Chapter 11.
101
Administrator Login Failure
If you are unable to perform an Administrator login (because the Username and
Password information has become corrupted, or you have forgotten it, for
example), you can clear the login information with the following procedure:
1. Power off the SN3101 and remove its housing.
2. Use a jumper cap to short the jumper labeled J4 (DEFAULT PASSWORD).
3. Power on the switch.
4. When the Link and 10/100Mbps LEDs flash, power off the switch.
5. Remove the jumper cap from J4.
6. Close the housing and start the SN3101 back up.
After you start back up, you can use the default Username and Password
(see Logging In, page 11) to log in.
sn3101.book Page 101 Monday, January 19, 2009 3:37 PM
Comments to this Manuals